3-3-3. Cutter
1.
2.
3.
4.
5.
6.
7.
8.
Remove the cover on the left side of the
machine above the copy exit (2 screws).
This allows the upper unit to be opened a
little more.
Open the upper unit.
Remove the rear cover (see section 3-1-3).
Remove plate [A] (1 screw).
Remove the sensor cover [B] (2 screws).
Remove the cutter [C] (1 connector, 2
screws)
Install the new cutter. The clearance [D]
between the cutter and the platen roller
must be 0.3 mm. Loosen the screws
removed in step 6 and move the cutter
back and forth to adjust the clearance.
Reassemble.
3-24
To Next Page
Loading...
