7. Buzzer Test
1. Enter the test mode. See page 2-22.
2. From the test mode menu, press 7. The buzzer will emit a tone for 8 minutes. Press Function or Stop at
any time to return to standby.
8. Sensor Initialization
1.
2.
3.
4.
5.
6.
FAX85: If possible, print out any messages received into the memory.
Switch the power off.
Cover all the printer sensors with paper.
Switch the power back on.
Enter the test mode (see page 2-22).
Press 8.
If NG is displayed with a sensor name next to it, replace that sensor, then repeat the initialization proce-
dure.
2-28
To Next Page
Loading...
