7. Remove the separation roller [H] (2
screws).
Caution: The diagram shows the roller disas-
sembled. There is normally no
need to disassemble the roller.
8. Reassemble the machine.
Caution: Do not touch the rubber surface of
the new roller, or document feed
problems will occur sooner than
normal.
Note: When putting back the operation
panel, pull down the part of the cover
that hangs above the document feed-
out area so that the pegs on the inside
of the cover fit into the slots in the
bracket above the document feed-out
area.
3-6
To Next Page
Loading...
