10. Press Yes.
11. Either:
To program parameters for another address, go back to step 3.
To return to standby, press Function.
- Bit Assignment -
Byte number 1
Bits 0 and 1 - Initial modem rate
Bit 1 0 Rate (bps)
0 0 9600
0 1 7200
1 0 4800
1 1 2400
Bits 2 to 5 - Tx level
Bit 2 3 4 5 Level (- dB)
and so on until
Bit 6 - Not used
Bit 7 - Dedicated Parameters Disable/Enable
0: Disabled - transmissions to this remote terminal
will use the parameters specified by the bit switches.
1: Enabled - the dedicated parameters in bytes 1 to 3
will be used.
2-16
To Next Page
Loading...
