No
Description
Formula Remarks
10 Pulse dial relay (PC2) make time
N (ms)
Note 1
11 Time between the final closure of the
N (ms)
Note 1
Di relay and the opening of the Ds
relay (Europe/Asia only)
12 Pause between dialled digits (pulse
N x 20 (ms)
Note 1
dial mode)
13 Time waited when a pause is
N x 20 (ms)
entered at the operation panel
14 DTMF tone length
N (ms)
15 Time between dial digits (DTMF dial
N (ms)
mode)
16 DTMF tone transmission level
3-N (dBm)
Note 3
Notes
1.
2.
3.
Pulse dial timing parameters (08 to 12) are the values for a dial rate of 10 pps. If 20 pps is used, the
machine adjusts these parameters; times for parameters 08 to 11 will be half those for 10 pps, and the
time for parameter 12 will be 3/4 of that for 10 pps.
The cpu may not detect the first ring until parameter 05 + ringing signal wavelength x (1 to 2.5).
N must be between 0 and 15.
2-68
To Next Page
Loading...
