101
Expanded Settings Menu
10
Compass Calibration
If a GP-1 is connected, its compass can be calibrated
by highlighting [Yes], pressing MENU/OK, and then
holding the camera in one hand and slowly moving it
through a large figure eight while rotating your wrist.
Each pass should take from five to eight seconds; a
beep will sound if calibration is successful, a warning
buzzer if it is not. Press DISP. to cancel and exit to
the expanded settings menu before calibration is
complete.
GPS Data Imprint
Select [On] to record GPS data with photographs taken while a GP-1 or Bluetooth®-
equipped GPS unit is connected. GPS data are recorded in the format selected for
[GPS Disp Mode] (GP.99). GPS data are not recorded when [Off] is selected or
when GPS data are unavailable.
UTC Data Imprint
Select [On] to record the time provided by the GPS unit with photographs taken
while a GP-1 or Bluetooth®-equipped GPS unit is connected. The time is not
recorded when [Off] is selected or when GPS data are unavailable.
Heading Data Imprint
If a GP-1 or a Bluetooth®-equipped GPS unit that supplies compass data is
connected, select [On] to record the compass heading in the format selected for
[Compass Heading] (GP.100). The compass heading is not recorded when [Off] is
selected or when GPS data are unavailable.
Range Finder Mode
Choose how data acquired from a Bluetooth®-equipped laser range finder (available
separately from third-party suppliers) are handled.
Available Settings Description
Mode1 Range data always appear in the picture display.
Mode2 Range data are displayed until a photograph is taken.
Mode3 Photos are taken automatically as range data are acquired.
To Next Page
Loading...
