Ricoh LW426 - When a Job Is Not Performed

Problem Causes Solutions
An error message remains,
even if misfed paper is
removed.
• When a misfeed
message appears, it
remains until you open
and close the cover as
required.
• Paper is still jammed in
the tray.
Remove misfed paper, and then open
and close the cover. See p.81
"Removing Jammed Paper".
Original images are printed
on the reverse side of the
paper.
You may have loaded the
paper incorrectly.
Load paper correctly. Load paper into
the cut paper tray print side down, and
into the bypass tray print side up. See
"Loading Paper", About This Machine
.
Misfeeds occur frequently. The cut paper tray's side
fences, end fence, or side-
end fences, might not be set
properly.
• Remove misfed paper. See
p.81 "Removing Jammed
Paper".
• Check the side fences, end fence,
and side-end fences are set
properly.
See "Changing the Paper
Size", About This Machine
.
Misfeeds occur frequently. Paper is wrinkled or folded. Cut folded or wrinkled areas off the
paper roll.
Remove cut paper that is folded or
wrinkled.
Misfeeds occur frequently. Jammed or torn paper is
inside the machine.
Remove the paper, as necessary. See
p.81 "Removing Jammed Paper".
Misfeeds occur frequently. You may have loaded paper
of a size different from the
paper size settings.
• Remove misfed paper. See
p.81 "Removing Jammed
Paper".
• Use Tray
Paper Size Settings to set
the paper size. See "Tray Paper
Settings", Network and System
Settings Reference
and "Copy
Paper", About This Machine
.
1. When the Machine Does Not Operate As Wanted
18
1