5857 002 Target 2:HDD 3:SD *CTL
Sets the storage location for the debug log.
[2 or 3 / 2 / 1/step]
2: HDD, 3: SD
5857 005 Save to HDD *CTL Sets the key number of the debug log.
5857 006 Save to SD Card *CTL Sets the key number of the debug log.
5857 009 HDD to SD Latest *CTL
Copies the most recent 4 MB of the debug log from
the hard disk to the SD card.
5857 010 HDD to SD Any *CTL
Sets the key number of the debug log copied from
the hard disk to the SD card.
5857 011 Erase HDD Debug *CTL Deletes the debug log from the hard disk.
5857 012 Erase SD Debug *CTL Deletes the debug log from the SD card.
5857 013 Dsply-SD Space *CTL Shows the free space on the SD card.
5857 014 SD to SD Latest *CTL
Copies the most recent 4 MB of the debug log from
an SD card to a different SD card.
5857 015 SD to SD Any *CTL
Sets the key number of the debug log copied from
an SD card to a different SD card.
5857 016 Make HDD Debug *CTL Makes a log file on the HDD to save debug logs.
To
save debug logs, the controller makes a log file
first, then writes data in the file. This procedure can
use much time. The user can switch off the main
power switch before the log is written in the file. To
prevent this possible problem, you can prepare a
log file in advance. If you do this, the controller uses
less time to save logs because the log file is
prepared.
5857 017 Make SD Debug *CTL
5858 [Debug Log Save: SC]
5858 001 Engine SC *CTL
Collects debug logs when an engine-related SC
code occurs.
[0 or 1 / 0 / 1/step]
0: OFF, 1: ON
Engine SP5-xxx
69
To Next Page
Loading...
