3
Shooting
44
u Caution
• When [HDR Capture] of the A1 menu is enabled and [Auto
Align] is set to T (On), [AUTO ISO Parameters] is fixed
to J.
You can set the Noise Reduction
setting when shooting with a high
ISO sensitivity in [High-ISO NR]
of the A2 menu or the control panel.
When [Custom] is selected, select
[Setting] and set the noise reduction
level according to the ISO sensitivity.
Choose the part of the sensor to use for measuring brightness
and determining exposure.
1 Turn R while pressing 2.
Noise Reduction when Shooting with
a High ISO Sensitivity
A2/v
Auto
Applies Noise Reduction at optimally calculated
levels throughout ISO range.
Low/
Medium/
High
Applies Noise Reduction at constant chosen level
throughout ISO range.
Custom
Applies Noise Reduction at user-defined levels for
each ISO setting.
Off Does not apply Noise Reduction at any ISO setting.
6400
AE Metering
A
Multi-
segment
Meters the brightness in multiple different
zones of the sensor.
In backlit conditions, this mode automatically
adjusts exposure.
B
Center-
weighted
Meters the brightness with an emphasis on the
center of the sensor.
The sensitivity increases at the center and
no automatic adjustment is performed even
in backlit conditions.
C
Spot
Meters the brightness only within a limited
area at the center of the sensor.
Useful when the subject is small.
To Next Page
Loading...
