CHANGING DEFAULT SETTINGS (SERVICE PROGRAM MODE)
Paper size detection selection
c1
Set your original on the expo-
sure glass or in the optional
document feeder.
El
While pressing the CS Mode
key, press the Number key you
have registered as Paper size
detection selection mode.
El
Enter the number of prints us-
ing the Number keys.
c1
, Press the Master Making key.
Check the image position of the
trial or proof print.
c1
If the image position is not correct,
adjust it using the Image Position
keys (* see page 21) or the side
plate fine adjusting dial (* see
page 22).
El
Make your prints.
—
- --.—-—.. -
————
To Next Page
Loading...
