CHANGING DEFAULT SEITINGS (SERVICE PROGRAM MODE)
User codes
With the user code function, operators must input an authorized code
before the machine will operate. The machine keeps rack of the number
of prints made under each code. In this mode, the following 20 user
codes (fixed) can be
used to access the machine.
382, 191, 182, 173, M4, 155, 146, 137, 128, 119,482,
291, 282, 273, 264, 255, 246,237, 228, 219
IJ To prevent unauthorized users from accessing the machine note down the
codes and then black out the codes from this manual.
How to enable user code mode (# 120)
The following procedure explains how to enable user code mode. This
must be done before a user code can be input.
n
Press the keys on the operation
panel in the following order.
(1)
Clear Modes key
(2) Clear key
(3) Enter key.
H
Enter “120” using the Number
keys and press the Enter key.
139
To Next Page
Loading...
