TROUBLESHOOTING
Check the following adjustments before restarting the printing run.
n
c1
El
c1
H
D
Is the paper feed pressure
properly adjusted?
The standard position of the pres-
sure lever is up. If you print on
thick paper (127.9 to 209.3 g/m2,
34.0 to 55.6 lb), push the lever
down.
Is the separation roller pressure
properly adjusted?
The standard position of the sepa-
ration pressure levers is the lower
position. If dog-eared or wrinkled
prints are delivered, push the lev-
ers up.
Are the side plate pads in the
correct positions?
To print on thin paper (47.1 to 52.3
g/m2, 12.5 to 13.9 lb), slide the lev-
ers (behind the paper feed side
plates) in the direction of the arrow
(see illustration).
175
s of originals are not recommended for use with the op-
eder. Set these types of originals on the exposure glass.
OPTIONAL FUNCTION!
Originals
a The following typ
tional document
f~
To Next Page
Loading...
