OPERATION
H
c1
c1
fl
*
b
c1
Press the Master Making key.
A trial print is delivered to the pa-
per delivery table.
Press the Proof key and check
the image density and the im-
age position of the proof print.
If the image position is not correct,
adjust it using the Image Position
keys or the fine adjustment dial.
(~ See pages 21 and 22.)
If the image density is slightly dark
or light, adjust the image density
by pressing the Speed keys. (*
See page 23.)
Press the Print
Start key.
After printing is completed, the
same number of prints is automat-
ically set for the next job.
if you want to stop the machine
during a print run, press the Stop
key.
Remove the prints from the pa-
per delivery table.
To clear all the modes you have
selected, press the Clear Modes
key.
If A4, 81/2” x 11” or smaller paper
is not delivered to the paper deliv-
ery table properly, set the small
size end plate prop to the small
size paper delivery end plate. *
See page 16.
Master Making
Stop
o~”
:
@
o
I
Print SWt
m
PrFl%tSW
Proof
;o~
Q
4
c1
#l
nter
To Next Page
Loading...
