PREPARING IMAGE MAKE-UP
When using the closed area method
CI
The line designating the area must be a closed loop.
El
B
Put the command sheet on top
of the original.
Using a black, red, or blue felt
tip pen, draw a line around the
area to designate. The line
should have a thickness of at
least 2 mm, 0.08”. Make sure
there is no break in the line.
Draw the line at least 2 mm,
0.08”, from the image so that
the complete image can be rec-
ognized.
4..
/
1
‘-to
@o
H-
*
0 %%
0 .--+:: ,
/
%
‘;,., ,.::-:,
/
0
Line marking the
designated
area
o
2mm/O.08°
Image within the
designated area
To Next Page
Loading...
