5. Post-Processing Option
Troubleshooting
Finisher SR5090/Booklet Finisher SR5100
Delivered Sheets Are Not Stacked Properly
Solution:
Depending on the cause of the problem, do one of the following:
Coated paper is being used.
<If the decurler unit is used>
In the [Main Unit: Paper Feed/ Output] group of [Adjustment Settings for Operators], select 0310:
[Correct Output Paper Curl] to correct П curl.
Set the correction level to either "Correction Level: Small" or "Correction Level: Large" according to
the paper type.
<If the decurler unit is not used>
When using coated paper, attach the support tray to the finisher upper tray.
There is airflow in the room.
Minimize the airflow. For instance, turn the air conditioner off.
Printed sheets are curled.
<If the decurler unit is used>
1. In the [Main Unit: Paper Feed/ Output] group on the [Adjustment Settings for Operators]
menu, select 0310: [Correct Output Paper Curl] and adjust the degree of decurling.
135
To Next Page
Loading...
