Cause:
Oblique (approximately 45°) thin lines or thin lines printed in faint colors are likely to contain breaks.
Solution:
1. In the [Main Unit: Image Quality] group on the [Adjustment Settings for Operators] menu,
select 0202: [Adjust Image Density] and execute [Adjust Image Density].
2. Print the image. Is the problem resolved?
Yes Finished!
No Go to the next step.
3. Increase the value by 1 in 0205: [Line Width].
4. Select 0202: [Adjust Image Density] and execute [Adjust Image Density].
5. Print the image. Is the problem resolved?
Yes Finished!
No Repeat Steps 3 to 5. If the problem persists even though you have increased the value to
5, contact your service representative.
Blurred Images
Lens-shaped blurred images appear at 314 mm (12.4 inches) intervals.
Density Problems
55
To Next Page
Loading...
