Ricoh Pro 8300S - Uneven Density Within 90 MM (3.5 In.) of the Trailing Edge

Solution:
1. Measure in millimeters how far the fainter area extends from the trailing edge.
2. Select [Machine: Image Quality] in [Advanced Settings] for the custom paper in use,
select 1204: [Paper Transfer Output Correction: Paper Edge] and configure the following
setting.
In [Trailing Edge Length], enter the value you measured in Step 1 plus an additional 10 mm.
3. Select [Machine: Image Quality] in [Advanced Settings] for the custom paper in use and
record the set values of [Trailing Edge] in 1204: [Paper Transfer Output Correction: Paper
Edge].
4. Increase the scaling factor in the above setting by 10 percentage points.
5. Print the image. Is the problem resolved?
Yes Finished!
No Increase the scaling factor by 5 percentage points.
6. Repeat Step 5. If the problem persists even though you have increased the scaling factor
by 50 percentage points, restore the value noted in Step 3 and go to the next step.
7. Decrease the scaling factor in the above setting by 10 percentage points.
8. Print the image. Is the problem resolved?
Yes Finished!
No Decrease the scaling factor by 5 percentage points.
9. Repeat Step 8. If the problem persists even though you have decreased the scaling factor
by 50 percentage points, restore the value noted in Step 3 and contact your service
representative.
Uneven Density within 90 mm (3.5 in.) of the Trailing Edge
Printing in the area extending approximately 90 mm (3.5 inches) from the trailing edge is fainter or
denser.
Density Problems
49