90 mm
(3.5 in.)
90 mm
(3.5 in.)
CEZ564
Cause:
This may occur if:
• Printing is done at low temperature or humidity
• Printing a single-dot halftone image
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Preparation.
Solution:
The solution depends on whether the area within 90 mm (3.5 inches) of the trailing edge is denser or
fainter.
<If the area within 90 mm (3.5 inches) of the trailing edge is fainter>
1. Select [Machine: Paper Feed / Output] in [Advanced Settings] for the custom paper in use
and check the set values of [Transfer Timing Roller] in 1351: [Motor Speed]. Is it the upper
limit value?
Yes Contact your service representative.
No Go to the next step.
2. Increase the value in [Transfer Timing Roller] by 0.1 percentage point.
3. Print the image. Is the problem resolved?
Yes Finished!
3. Troubleshooting Image Quality Problems
50
To Next Page
General
