Output tray
Paper exit
Paper feed direction
Trailing edge
too near exit
CEZ593
Solution:
1. Attach the Z-fold support tray for multi-folding unit.
2. Print the image. Is the problem resolved?
Yes Finished!
No Go to the next step.
3. In the [Main Unit: Paper Feed/ Output] group on the [Adjustment Settings for Operators]
menu, set 0310: [Correct Output Paper Curl] to "U Curl Correction Level".
Select "Large" or "Small" to control the level of decurling as required.
4. Print the image. Is the problem resolved?
Yes Finished!
No Contact your service representative.
• For details about attaching the Z-fold support tray for multi-folding unit, see "Preparation" supplied
with the machine.
• If the Z-fold support tray for multi-folding unit is attached, the trailing edge of the ejected sheets will
not be too close to the paper exit, so no problem will occur. However, the stapled sheets may not
be stacked properly.
Finisher SR5110/Booklet Finisher SR5120
145
To Next Page
Loading...
