2. Is the paper curl within the curl standard?
Yes Proceed to Step 6.
No Go to the next step.
3. Place the curled surface down on a flat surface.
4. Hold the end of the paper and straighten it in the opposite direction to the curl direction so
that the paper is rounded.
5. Is the problem resolved?
Yes Finished!
No Go to the next step.
6. Remove the paper, loosen it, and reset it.
7. Is the problem resolved?
Yes Finished!
No Go to the next step.
8. Select [Machine: Paper Feed / Output] in [Advanced Settings] for your custom paper
being used, select 1331: [Interposer] and adjust the value in [Fan Level].
• If the present value is 10%:
Increase the value in [Fan Level] to 30%.
• If the present value is 30%:
Increase the value in [Fan Level] to 50%.
• If the present value is 50%:
Increase the value in [Fan Level] to 80%.
• If the present value is 80%:
Increase the value in [Fan Level] to 100%.
9. Is the problem resolved?
Yes Finished!
No Go to the next step.
10. Select 1331: [Interposer] and adjust the value in [Fan Level].
• If the present value is 30%:
Increase the value in [Fan Level] to 50%.
• If the present value is 50%:
5. Post-Processing Option Troubleshooting
174
To Next Page
Loading...
