(a) Increase the current value
1. Select [Machine: Image Quality] in [Advanced Settings] for the custom paper in use, and
then record the set values of [Leading Edge] and [Leading Edge Length] in 1204: [Paper
Transfer Output Correction: Paper Edge].
2. For [Leading Edge Length], is the set value the upper limit?
Yes Go to Step 7.
No Increase the set value by 5 percentage points.
3. Print the image. Is the problem resolved?
Yes Finished!
No Go to the next step.
4. For [Leading Edge], is the set value lower than 200?
Yes Increase the set value by 10 percentage points.
No Reset [Leading Edge] to the initial value and repeat the steps from Step 2.
5. Print the image. Is the problem resolved?
Yes Finished!
No Repeat the steps from Step 4.
6. If the problem is not resolved by repeating the steps from Step 4 to increase the value of
[Leading Edge] to "200", reset it to the value noted in Step 1 and go to Step "(b) Decrease
the current value".
7. For [Leading Edge], is the set value lower than 200?
Yes Increase the set value by 10 percentage points.
No Switch to a different paper type.
8. Print the image. Is the problem resolved?
Yes Finished!
No Repeat the steps from Step 7.
9. If the problem is not resolved by repeating the steps from Step 7 to increase the value of
[Leading Edge] to "200", reset it to the value noted in Step 1 and go to Step "(b) Decrease
the current value".
Density Problems
47
To Next Page
Loading...
