Cause:
This may occur if:
• Continuously printing an image that consumes little toner
• The machine has not been used for a long time
• The machine is located somewhere very humid and has not been used for a while
Solution:
1. In the [Main Unit: Image Quality] group on the [Adjustment Settings for Operators] menu,
select 0202: [Adjust Image Density] and execute [Adjust Image Density].
2. Print the image. Is the problem resolved?
Yes Finished!
No Go to the next step.
3. Increase the value by 1 in 0204: [Maximum Image Density].
4. Select 0202: [Adjust Image Density] and execute [Adjust Image Density].
5. Print the image. Is the problem resolved?
Yes Finished!
No Repeat Steps 3 to 5. If the problem persists even though you have increased the value to
5, contact your service representative.
Color Is Too Dense
The entire image is denser than normal.
Density Problems
53
To Next Page
Loading...
