Printing problems about duplex function
Problem Cause Solution
Cannot print in duplex mode. You cannot select duplex
printing if the paper type is set
to [Tab Stock], [Translucent
Paper], [OHP
(Transparency)], [Label
Paper], or [Preprinted Paper].
In [Tray Paper Settings], under "Tray
2-7", select a paper type other than [Tab
Stock], [Translucent Paper], [OHP
(Transparency)], [Label Paper], or
[Preprinted Paper]. For details about
accessing tray paper settings, see
"Accessing Tray Paper Settings",
Network and System Settings Guide
.
Slip sheets are not inserted
when printing in duplex
mode.
You cannot select duplex
printing if [Tab Stock],
[Translucent Paper], [OHP
(Transparency)], [Label
Paper], or [Preprinted Paper]
is selected as the paper type
for slip sheets.
In [Tray Paper Settings], under "Tray
2-7", select a paper type other than [Tab
Stock], [Translucent Paper], [OHP
(Transparency)], [Label Paper], or
[Preprinted Paper]. For details about
accessing tray paper settings, see
"Accessing Tray Paper Settings",
Network and System Settings Guide
.
With [Duplex-Flip on Short
Edge] for stapling, even-
numbered pages are printed
upside down.
Two staple positions are
selected with [Duplex-Flip on
Short Edge] when using the
duplex printing.
If you have selected [Duplex-Flip on
Short Edge] for stapling with duplex
printing, you must then select a staple
position. Select only one staple position.
If you select two staple positions, even-
numbered pages may be printed upside
down.
Other printing problems
Problem Cause Solution
It takes a long time to
complete a print job.
"Sleep mode" might be set. The machine requires time to warm up if
it has been in "Off mode/Sleep mode".
Specify "Off mode/Sleep mode" in
[System Settings], [Auto Off Timer].
Other Printing Problems
41
To Next Page
Loading...
