Default: [200]
• Status Monitor Interval
Specify the monitoring interval of "Managed User Host Limit" and "Password Entry Host
Limit".
Use the number keys to specify the value between "1" and "10", and then press [ ].
Default: [3]
• Off
Default: [Off]
Device Access Violation
The machine administrator can specify this.
If the number of login requests exceeds the number specified by the setting, the system recognizes
the access as an access violation. The access is recorded in the Access Log and the log data is sent
to the machine administrator by e-mail. Also, a message is displayed on the control panel and on
Web Image Monitor.
If the "Max. Allowed No. of Access" is set to [0], access violations are not detected.
In "Authentication Delay Time", you can specify response delay time for login requests to prevent
the system from becoming unresponsive when an access violation is detected.
In "Simultns. Access Host Limit", you can specify the maximum number of hosts that access the
machine at one time. If the number of simultaneous accesses exceeds the number specified by the
setting, monitoring becomes unavailable and the machine's monitoring status is recorded in the
Log.
• Max. Allowed No. of Access
Specify the maximum number of allowable access attempts.
Use the number keys to specify the value between "0" and "500", and then press [ ].
Default: [100]
• Measurement Time
Specify the interval between excessive accesses. When the measurement time elapses, the
records of excessive accesses are cleared.
Use the number keys to specify the value between "10" and "30", and then press [ ].
Default: [10]
• Authentication Delay Time
Specify authentication delay time when an access violation is detected.
Use the number keys to specify the value between "0" and "9", and then press [ ].
Default: [3]
• Simultns. Access Host Limit
6. Managing the Machine
166
To Next Page
Loading...
