Feeding paper
To prevent multiple sheets from being fed at once, fan the paper before loading it. If you load
paper when only a few sheets of paper remain in the tray, multiple sheet feeding may occur.
Remove any remaining paper, stack them with the new sheets of paper, and then fan the entire
stack before loading it into the tray.
(1) Loosen the stack by riffling the sheets. Holding its shorter ends, flex the stack back and
forth to create space between the sheets. Repeat this several times. Fan the stack slowly
so that space can be created between the sheets.
(2) Make sure there is enough space between the sheets, hold the paper with both hands
and use a flat surface to align the long and short sides of the paper.
Cautions when setting paper to Vacuum Feed LCIT RT5120
When setting a paper to Vacuum Feed LCIT RT5120, adjust locations of side and end fences
according to the paper size. Good and bad examples of loading paper are described below. Follow
the "Good example".
Good example
① Back of tray
Set a paper flush against the face plate.
② Side fences
③ End fence
Adjust each fence little by little and align the side fence with
the width of the paper. Do not make the width too narrow that
causes "bending" or "wrinkle". Also, make sure that there is
no space between each fence and paper.
To Next Page
Loading...
