Specifying "Envelope" with color controller driver
To specify "Envelope" as a print paper with color controller, follow the below procedure.
(1) Select the [Finishing] tab and specify [Output delivery:] as [Face up - normal order].
(2) Open the [Media] tab, and select the envelope registered as custom paper from Paper
Catalog.
Image
Caution:
• For manual selection, specify [Paper type], [Paper weight] and [Paper size] according to the
envelope.
• If the desired print position cannot be set, use [Shift mode] in the [Finishing] tab. Enter numer-
ical values in the direction you want to move the print position (by-axis).
Setting guide for envelope to tray
RICOH Pro C9200 series has a guide to adjust the height when a printed paper is output. Set
the guide to the tray when printing on envelopes.
(1) Press the Power button near the tray. When the tray starts to move down, wait for a few
seconds until it stops.
When pressing the power button near the tray, the button lights up in orange.
(2) Attach the support tray by inserting the two protrusions on its underside of support tray
into the holes on the finisher shift tray.
To Next Page
Loading...
