Ricoh Pro C9200 Series - 0605 Paper Alignment for Stapling: With Feed; 0606 Number of Sheets Align for Stapling

  
%

J471
J485
J486
J500
J501
• Fan the papers before loading.
• Correct curling of the papers before loading.
• Perform the below settings in custom paper set in the tray to prevent papers to stick
together. (Try the settings in order from 1 to 2)
1. [Advanced Settings] - [1301 Main/2-Tray LCIT: Paper Feed Mode] - [01: Paper Feed
Mode: Fan Level] - [Prevent Double Feed (Weaker Blow)]
2. [Advanced Settings] - [1301 Main/2-Tray LCIT: Paper Feed Mode] - [01: Paper Feed
Mode: Fan Level] - [Prevent Non Feed (Weakest Blow)]
For a paper below, specify the following settings in addition to the above settings.
◎ Thin papers that allow air to pass through easily (e.g. recycled paper)
• Go to [Advanced Settings] - [1302:2-Tray LCIT: Fan/Shutter] - [Vacuum Fan Level] [24:
Size  - [24:] [70%] to [50％] (Try in order of [70%], [60%], [50%])
* This is to prevent multiple sheets of thin paper from being fed.