3. Details of Detailed Settings
This chapter explains the functions of the Detailed settings and the related image quality problems that
can be prevented/improved by adjusting these settings. For detailed procedure, see the
Troubleshooting manual.
Overview
Print Mode
Image quality is adjusted in balance with productivity according to the print mode (BW/FC), which
differ in the maximum toner amount, i.e. bias needed for transfer and heat needed for fusing.
It is important not to mix up the adjustments, especially the items that have similar names like 1241:
[Fusing Temperature].
The following table describes the relation between the pint mode and the image data sent from the color
controller.
Print data Print mode Max toner amount
K only BW 100%
CMYK
*1
FC 260%
*1
Job is run in FC mode, if the print data contains C, M, or Y.
31
To Next Page
Loading...
