• Belt-to-paper transfer: Length of area to apply correction at leading edge of paper
• Belt-to-paper transfer: Length of area to apply correction at trailing edge of paper
• Current vs. Voltage
• Bias is applied using 'constant current' for photoconductor unit-to-belt and belt-to-paper
transfer, as this method is resilient to changes in operational environment and thickness of the
media.
• On the other hand, 'constant voltage' is used for AC bias and as this method does not require
adjustments according to paper width.
Related Advanced Settings
page 36 "Paper Transfer Output Correction: Paper Edge"
Paper transfer belt Rotation Speed
The Paper transfer belt [1] has the function to deliver the paper from the paper transfer timing roller.
1. Paper transfer belt
Since the paper transport speed is controlled by the Paper transfer belt Rotation Speed, if the Paper
transfer belt Rotation Speed is slower than the target the image will shrink, if faster than the target the
image will stretch.
A problem such as in-track image magnification misalignment and mottling on black half-tone parts may
occur in the printed image because of the speed difference relative to the Intermediate transfer belt. To
solve this problem, it is necessary to adjust the Paper transfer belt Rotation Speed.
Since the paper is simultaneously gripped by the Paper transfer belt Rotation Speed and the paper
transfer timing roller, uneven density and banding problems may occur, if the speed differs between
these rollers. To prevent this problem, you can adjust the Paper transfer belt Rotation Speed.
Related Advanced Settings
page 52 "Paper Transfer Belt"
Belt-to-Paper Transfer
13
To Next Page
Loading...
