Image Position Feedback Correction
1103 [Image Position Feedback Correction]
Function
Select the Image Position Feedback Correction mode.
If [No Detection Mark] is selected, the image position is adjusted according to the shape of paper.
If [Detection Mark] is selected, detection marks are applied on four corners of the paper and
image position is adjusted according to the shape of paper and the marks.
[No Detection Mark] is less accurate than [Detection Mark].
If not required, select [Correction Off].
When to use
Specify this setting if the absolute position or image alignment between the front and back of the
paper shifts over the time. If [Detection Mark] is selected, detection marks are applied to the four
corners of the paper. Use this for the jobs in which the detection marks are used for cutting the
paper. [No Detection Mark] is effective for adjustment of skews and misregistration due to paper
misalignment that occurs when the magnification differs between the front (Side 1) and back (Side
2) of the paper.
Image Position Gap
1104 [Image Position Gap]
Function
Adjusts the position and magnification of the image to be printed on the paper.
When to use
To adjust the absolute position.
To align the images printed on the front and back sides of the paper.
• The value for image position adjustment is linked to the value for [Manual Adjustment] in [Image
Position Gap] in the [Media] hub. Adjust the value in [Manual Adjustment].
Registration
33
To Next Page
Loading...
