Loading Paper into the Paper Tray
This section explains how to load paper in Trays 1 to 2 and the wide large capacity tray.
Each paper tray is loaded in the same way. The wide LCT is identified as Tray 3, Tray 4, Tray 5, Tray 6,
Tray 7, and Tray 8.
• Check the paper edges are aligned on the left side.
• Depending on the degree of paper curl, a notification indicating that the paper tray is overloaded
may appear even if the height of the loaded paper stack remains below the upper limit sign. If this
notification appears, remove the paper from the tray, and load it again.
1. Check that paper in the paper tray is not being used, and then pull the tray carefully out
until it stops.
2. Remove paper if loaded.
3. Release the fence.
Loading Paper into the Paper Tray
13
To Next Page
Loading...
