Removing Chad and Paper Debris
Punching
1. Press the Alarm icon ( ), and then press "Hole Punch Receptacle is full." under "System
Messages".
2. Follow the procedure that is shown in the animation to dispose of the punch waste.
Stapling
1. Confirm the message.
"Waste Staple Receptacle is full."
2. Follow the procedure that is shown in the animation to remove the staple waste.
Paper Cutting
1. Confirm the message.
"Trimmer Waste Paper Receptacle is full."
2. Follow the procedure that is shown in the animation to dispose of the cutting scraps.
6. Replacing Consumables
58
To Next Page
Loading...
