Loading Envelops
Open the flap, and load the envelopes with the print side facing up and the flaps facing rightward.
When loading the envelopes on wide LCT, make sure the difference in height at the bottom of the
envelopes and the at the tip of the flaps is less than 10 mm (0.4 inches).
• Before loading envelopes on the tray, press down on them to remove any air inside and to flatten
any edges or creases. Also, if the loaded envelopes are curled, correct the paper curl so that the
amount of curl is 5 mm (0.2 inches) or less.
• Place envelopes on the tray so that they are not stacked above the upper limit sign of the tray. If
paper jam, unfed paper, double-feeding, or another paper feeding problem persists even after
correcting the paper curl, load one envelope (single sheet of paper) at a time.
• If a paper jam occurs while using wide LCT, load five more envelopes.
Loading Envelops
43
To Next Page
Loading...
