2. Extender
To remove the fence, slide it to the right by pressing the stopper down.
3. Press the elevator switch on the multi bypass tray (Tray A).
1. Elevator switch
The lamp of the elevator switch is blinking while the tray is going up, and keeps lit when it stops.
Press the elevator switch to move down the tray if you want to either add paper or remove jammed
ones.
• Pull the extender out when loading A4 , 8
1
/
2
× 11 or larger sheets in the multi bypass tray
(Tray A).
• You can load envelopes into the multi bypass tray (Tray A). Envelopes must be loaded in a specific
orientation. For details, see below.
• "Envelope Orientation and Recommended Status"
• If multiple sheet feeding occurs, fan sheets thoroughly or load sheets one by one from the multi
bypass tray (Tray A).
• Specify the sizes of paper that are not automatically detected. For details about how to specify
sizes, see "Specifying the Paper Size That Is Not Automatically Detected". For
details about the sizes that can be detected automatically, see page 20 "Recommended Paper
Sizes and Types".
Loading Paper into the Multi Bypass Tray (Tray A)
19
To Next Page
Loading...
