SERVICE PROGRAM MODE 10 August, 2001
4-8
1
Mode Number/Name Function/[Setting]
Fusing Nip Band Check109
Checks the fusing nip band (☛ 4.2.11)
[1 = Start / 0 = Stop]
AC Frequency Display902
Displays the fusing lamp power control frequency
which is detected by the zero cross signal generator.
Under “54” equals 50 Hz. Otherwise, 60 Hz.
Feed Clutch Re-energize
1 By-pass Feed
Adjusts the paper feed amount allowed by the clutch
(see the table below) after correcting the skew at
registration.
[0 ~ 10 / 6 / 1 mm/step]
2 1st Paper Tray
903*
3 Other Paper Trays
When paper jams occur after restarting paper feed
after registration, increase the value to help the
registration roller feed the paper.
[0 ~ 10 / 0 / 1 mm/step]
Tray Paper Full Detection905*
Determines whether or not to detect if the built-in copy
tray is full.
[0 = No / 1 = Yes]
Tray Paper Full Timer906*
Adjusts the time that the paper overflow sensor must
remain on before a message appears on the LCD. The
sensor may be switched on and off again if the paper
is curled, giving a false tray full detection. This SP
prevents this problem.
This SP mode is used when SP1-905 is set to 1.
[100 ~ 5000 / 500 / 10 ms/step]
1st Bottom Plate Pressure Adjustment908*
1 Normal Size If a middle size threshold is not stored with SP1-908-9,
this SP adjusts the upper paper lift motor reverse time
for paper sizes larger than the small size threshold set
with SP1-908-8.
If a middle size threshold is stored with SP1-908-9,
then this SP adjusts the motor reverse time for sizes
larger than the middle size.
Do not input a value greater than 1,200.
Use this SP when a paper feed problem occurs from
the 1st paper tray.
See “Paper Lift Mechanism” for details on SP1-908.
[0 ~ 2000 / 200 / 1 ms/step]
Paper Feed Station Clutch
By-pass Feed Upper Relay
1st Paper Tray 1st Paper Feed
Other Paper Trays Upper Relay
To Next Page
Loading...
