Ricoh Russian-C2a - Page 173

SERVICE PROGRAM MODE 10 August, 2001
4-10
1
Mode Number/Name Function/[Setting]
1st Paper Size
8 1st Small Paper Size
Setting
Selects the small size threshold for the 1st paper tray.
“0” means that this setting is not used.
The size used by SP1-908 is determined by paper
width. See “Paper Lift Mechanism” for details on SP1-
908.
[0 = None (Not used) / 1 = HLT/A5 / 2 = A4 / 3 = LT / 4
= DLT / 5 = A3]
908*
9 1st Middle Paper Size
Setting
Selects the middle size threshold for the upper tray.
“0” means that this setting is not used.
The value must be larger than the small size threshold
(SP1-908-8). The size used by SP1-908 is determined
by paper width. See “Paper Lift Mechanism” for details
on SP1-908.
[0 = None (Not used) / 1 = HLT/A5 / 2 = A4 / 3 = LT /
4 = DLT / 5 = A3]
2nd Bottom Plate Pressure Adjustment
1 Normal Size If a middle size threshold is not stored with SP1-909-9,
this SP adjusts the upper paper lift motor reverse time
for paper sizes larger than the small size threshold set
with SP1-909-8.
If a middle size threshold is stored with SP1-909-9,
then this SP adjusts the motor reverse time for sizes
larger than the middle size.
Do not input a value greater than 1,200.
Use this SP when a paper feed problem occurs from
the 2nd paper tray.
See “Paper Lift Mechanism” for details on SP1-909.
[0 ~ 2000 / 200 / 1 ms/step]
2 Small Size Adjusts the upper paper lift motor reverse time for
paper of the same size as or smaller than the small
size threshold set with SP1-909-8.
Do not input a value greater than 1,200.
Use this SP when a paper feed problem occurs from
the 2nd paper tray.
See “Paper Lift Mechanism” for details on SP1-909.
[0 ~ 2000 / 600 / 1 ms/step]
909*
3 Middle Size Adjusts the upper paper lift motor reverse time for
paper sizes larger than the small size threshold set
with SP1-909-8, up to and including the middle size
threshold set with SP1-909-9. If a middle size
threshold is not stored with SP1-909-9, this SP is not
used.
Do not input a value greater than 1200.
Use this SP when a paper feed problem occurs from
the 2nd paper tray.
See “Paper Lift Mechanism” for details on SP1-909.
[0 ~ 2000 / 200 / 1 ms/step]