Ricoh Russian-C2a - Page 198

10 August, 2001 SERVICE PROGRAM MODE
4-35
Service
Tables
5
Mode Number/Name Function/[Setting]
CC Call
1 Remain of Jam
(Unattended Jam)
Switches the control call on/off for an unattended jam.
Japan only DFU
0: Off, 1: On
If you select “1”, the alarm sound if a jam is left
unattended for 15 minutes.
2
Continuous Jam
Occurrence
Switches the control call on/off for the occurrence of
consecutive jams. Japan only DFU
0: Off, 1: On
If you select “1”, the alarm will sound if 5 consecutive
jams occur in the copier.
3 Continuous Door Open Switches the control call on/off for the cover open
alarm. Japan only DFU
0: Off, 1: On
If you select “1”, the alarm will sound if the door
remains open for 15 minutes.
4 New CC Call Mode
Selects whether or not the new CC call.
Japan only DFU
0: Previous Mode, 1: New Mode
11 Time for Remain of
Jam
This SP is effective when the value of SP5-508-4 is “1”.
Japan only DFU
[3 ~ 30 / 10 / 1 min/step]
12
Number of continuos
Jam
This SP is effective when the value of SP5-508-4 is “1”.
Japan only DFU
[2 ~ 10 / 5 / 1 time/step]
13 Time of Continuous
Door Open
This SP is effective when the value of SP5-508-4 is “1”.
Japan only DFU
[3 ~ 30 / 10 / 1 min/step]
21 Remain of Jam Mode
(Unattended Jam)
This SP is effective when the value of SP5-508-4 is “1”.
Japan only DFU
0: Auto Call, 1: Alarm
22
Continuous Jam
Occurrence Mode
This SP is effective when the value of SP5-508-4 is “1”.
Japan only DFU
0: Auto Call, 1: Alarm
508*
23
Continuous Door Open
Mode
This SP is effective when the value of SP5-508-4 is “1”.
Japan only DFU
0: Auto Call, 1: Alarm
Memory All Clear Resets all correction data for process control and all
software counters, and returns all modes and
adjustments to their default values. (☛ 4.2.7).
To execute, hold down
#
for over 3 seconds, and then
turn the copier off and on again.
Use this SP only after replacing the NVRAM, or after
the copier has malfunctioned due to a damaged
NVRAM.
1 All modules Initializes items 2 ~ 12 below.
2 Engine Initializes all registration settings for the engine and
processing settings.
801
3 SCS (System Control
Service)/SRAM
Initializes default system settings, CSS settings,
operation display coordinates, and ROM update
information.
SCS: System Control Service