Ricoh Russian-C2a - Page 199

SERVICE PROGRAM MODE 10 August, 2001
4-36
5
Mode Number/Name Function/[Setting]
4
IMH (Image Memory
Handler)
Initializes the registration setting for the image
memory handler.
5
MCS (Memory Control
Service)
Initializes the automatic delete time setting for stored
documents.
6 Copier application Initializes all copier application settings.
7 Fax application
Initializes the fax reset time, job login ID, all TX/RX
settings, local storage file numbers, and the off-hook
timer.
8 Printer application Initializes the printer defaults, programs registered,
the printer SP bit switches, and printer CSS counter.
9 Scanner application Initializes the scanner defaults for the scanner and
all the scanner SP modes.
10 Network application
Deletes the network file application management
files and thumbnails, and initializes the job login ID.
11 NCS (Network Control
Service)
Initializes the system defaults and interface settings
(IP addresses also), SmartNetMonitor for Admin,
WebStatusMonitor settings, and the TELNET
settings.
801
12 R-FAX
Initializes the job login ID, SmartNetMonitor for
Admin, job history, and local storage file numbers.
Free Run802
Performs a free run for both the scanner and the
printer.
After selecting “1”, press “OK” or the
'
key twice to
start this feature. Press the
&
(Clear/Stop) key to stop.
[0 = No / 1 = Yes]
Input Check803
Displays signals received from sensors and switches.
Press the
"
(Clear Modes) key to exit the program.
(☛ 4.2.4)
Output Check804
Turns on electrical components individually for test
purposes. (☛ 4.2.5)
Option Connection Check
1
ARDF
2
Bank (Paper Tray Unit)
3
LCT
807*
4
Finisher (1000-sheet,
Two-Tray finisher)
Checks the connectors to the optional peripheral
devices. Execution will return either a “1” or “0”:
1: Device connected correctly.
0: Device not connected correctly.
SC Code Reset810
1 Fusing SC Resets all level A service call conditions, such as fusing
errors. DFU
To clear the service call, touch “Execute” on the LCD,
then turn the main power switch off/on.
Serial Number Input811
Use to input the machine serial number. (This is
normally done at the factory.)
This serial number will be printed on the SMC report.