Ricoh SP 200S - Page 254

Message Causes Solutions
Cannot Print
Memory Overflow
The data is too large or
complex to print.
Select [600 x 600dpi] in [Resolution:] to
reduce the size of data. For details, see the
Printer Driver Help.
Size Mismatch:
Tray1
Press Start or Stop
The specified paper size of the
file does not match that of the
paper loaded in Tray 1.
• Press the [ ] key to begin printing,
or press the [ ] key to
cancel the job.
• If [Auto Continue] is set to [0 sec.], no
error message appears.
Size
Mismatch:Bypass
Press Start or Stop
The specified paper size of the
file does not match that of the
paper loaded in the bypass
tray.
Press the [ ] key to begin printing, or
press the [ ] key to cancel the
job.
Type Mismatch:
Tray1
Press Start or Stop
The specified paper type of the
file does not match that of the
paper loaded in Tray 1.
• Press the [ ] key to begin printing,
or press the [ ] key to
cancel the job.
• If [Auto Continue] is set to [0 sec.], no
error message appears.
Scan Disconnected
The USB cable or Ethernet cable
was disconnected while
scanning from a computer.
Reconnect the USB cable or Ethernet cable
properly, and then try the operation again.
Cannot Connect
#### Server
The connection with the FTP/
SMTP/POP3/SMB server was
lost while sending or receiving
data.
If the problem involves the FTP/SMB
server, check the [Edit Network Scan
Destination] setting in Smart Organizing
Monitor.
If the problem involves the SMTP/POP3
server, check the [Server Properties...]
setting in Smart Organizing Monitor.
Cannot Obtain IP
#### Server
The machine cannot obtain an
IP address from the FTP/SMTP/
POP3 server.
If the problem involves the FTP server,
check the [Edit Network Scan Destination]
setting in Smart Organizing Monitor.
If the problem involves the SMTP/POP3
server, check the [Server Properties...]
setting in Smart Organizing Monitor.
10. Troubleshooting
168