• Horiz.: Bypass Tray (-6 to +6 mm, in 1 mm increments)
• Vert.: Bypass Tray (-6 to +6 mm, in 1 mm increments)
Low Humidity Mode
When the machine is used in a low humidity environment, black stripes with a few millimeters width
may appear. Selecting [On] should prevent such black stripes from appearing.
Default: [Off]
• On
• Off
Image Density
Adjusts the density of printing.
Default: 0
• -3 to +3
Fusing Unit Amelrtn.Mode
If the toner is not transferred properly, causing the paper to be stained, select [On] to improve
transferability.
Default: [Off]
• Off
• On
System Settings
opal-p2_mf2_com_user_guide_00142125_eng.xml 149
To Next Page
Loading...
