To configure this setting, contact your telephone company and select the setting based on your
telephone line. Selecting a wrong setting may cause failures in fax transmissions.
[Dial Phone (20PPS)] may not appear depending on the country setting of the machine.
Default: [Push Phone]
• Push Phone
• Dial Phone (10PPS)
• Dial Phone (20PPS)
PSTN / PBX
Sets the machine to connect to the public switched telephone network (PSTN) or a private branch
exchange (PBX).
Default: [PSTN]
• PSTN
• PBX
PBX Access Number
Specifies the dial number to access the outside line when the machine is connected to a PBX.
Make sure that this setting matches the setting of your PBX. Otherwise, you may not be able to send
faxes to outside destinations.
Default: 9
• 0 to 999
Function Priority
Specifies the mode that is activated when the power is turned on, or if the time specified for [System
Auto Reset Timer] elapses without activity while the initial screen of the current mode is displayed.
Default: [Copier]
• Copier
• Facsimile
• Scanner
System Auto Reset Timer
Sets the machine to return to the mode specified in [Function Priority].
This setting is also applied to the timeout for copying the next document while ID card copy.
Default: [On] (30 sec.)
• On (30 sec., 1 min., 2 min., 3 min., 5 min., 10 min.)
• Off
7. Configuring the Machine Using the Control Panel
160 opal-p2_mf2_com_user_guide_00142129_eng.xml
To Next Page
Loading...
