Energy Saver Mode
Sets the machine to enter Energy Saver mode, Energy Saver mode 1 or Energy Saver mode 2, to
reduce power consumption. The machine recovers from Energy Saver mode when it receives a
print job, prints a received fax, or when [Copy] or [Start] key is pressed.
• EnergySaverMode 1
The machine enters Energy Saver mode 1 if the machine has been idle for about 30 seconds.
It takes less time to recover from Energy Saver mode 1 than from power-off state or Energy
Saver mode 2, but power consumption is higher in Energy Saver mode 1 than in Energy
Saver mode 2.
Default: [Off]
• Off
• On (30 seconds)
• EnergySaverMode 2
The machine enters Energy Saver mode 2 after the period of time specified for this setting is
passed. The machine consumes less power in Energy Saver mode 2 than in Energy Saver
mode 1, but it takes longer to recover from Energy Saver mode 2 than from Energy Saver
mode 1.
• Europe
Default: [1 minute]
The time can be set from 1 to 30 minutes.
• Countries other than European countries
Default: [On] (1 minute)
• On (1 to 240 minutes, in 1 minute increments)
• Off
Language
Specifies the language used on the screen and in reports.
Area (Europe only)
By selecting the area in which the machine is being used, you can narrow down the choice of
display language and other settings.
You can also specify this setting during the initial setup after turning the power on for the first time.
Default: [Europe]
• Europe
• Asia
• Oceania
• Americas
Administrator Settings
opal-p2_mf2_com_user_guide_00142129_eng.xml 161
To Next Page
Loading...
