Ricoh SP 311DNW - Page 10

RICOH SP 311DNw B&W Network Laser Printer
Getting Started Guide
10
Note:
• Connection Succeeded: If the Power indicator lights up, the connection between the
printer and router was successful.
• Connection Failed: If all indicators flash simultaneously, and after 30 seconds only the
Power indicator lights, the connection failed. Check that the router is
working properly and try again.
Important:
• If you are configuring the printer again, for instance, you changed the device’s location, use the
following method to reset the printer to factory defaults, and then repeat steps 1 - 2.
a. Turn printer power switch Off.
b. Press and hold [Job Reset] and [Stop/Start].
c. Turn printer power switch On.
d. When Alert indicator (middle light) starts flashing red, release keys.
e. Restart the printer; turn power switch Off, wait a moment, and then turn On.
3. Next, install Network Printer Driver and Utility. See 3.2 Network Quick Install
.