RICOH SP 311DNw B&W Network Laser Printer
Getting Started Guide
32
Appendix
E
Add New Port
If you would like to bypass the install wizard and have more control over printer port
creation, the steps for manually adding a port are outlined below.
Before proceeding, please check the following:
• Printer power switch is On.
• Network is connected and configured.
• Printer’s IP address is available. If the printer was previously configured, with IP address assigned,
the Configuration Report show the address. See Appendix B: Print Configuration Report.
To add a new printer port, proceed as follows:
1. Click [Start] [Devices and Printers].
2. Right-click [RICOH SP 311DNw] icon.
3. Select [Printer properties].
To Next Page
Loading...
