Ricoh SP 311DNW - Page 42

RICOH SP 311DNw B&W Network Laser Printer
Getting Started Guide
42
Encryption
Select encryption method based on chosen Authentication method.
• Open System: Choose [None] or [WEP]
• Shared Key: [WEP] only
• WPA2-PSK: Choose [CCMP (AES)] or [TKIP/EAS]
•
Mixed Mode WPA/WPA2: Choose [CCMP (AES)] or [TKIP/EAS]
WPA Passphrase
If [WEP] is selected for Encryption method, enter enabled fields. If [WPA2-PSK] or
[Mixed Mode WPA/WPS2] is selected for Authentication, enter enabled fields.
WEP Key Length
Select 64 bits or 128 bits for the length of the WEP encryption key.
WEP Transmit
Key ID
Select an ID number to identify each WEP key in case multiple WEP connections
are configured.
WEP Key Format
Select a format for entering the WEP key.
WEP Key
Enter the WEP key. The number and type of characters you can enter vary
depending on the length and format selected for the key, as follows:
• WEP key length: [64bits], Format: [Hexadecimal]
WEP key max length: 10 characters (0-9, A-F, a-f)
• WEP key length: [64bits], Format: [ASCII]
WEP key max length: 5 characters (ASCII characters)
• WEP key length: [128bits], Format: [Hexadecimal]
WEP key max length: 26 characters (0-9, A-F, a-f)
• WEP key length: [128bits], Format: [ASCII]
WEP key max length: 13 characters (ASCII characters)
5. When finished, click [OK] to save changes.
6. Close web browser.
7. Disconnect Ethernet cable.
8. Turn printer power switch Off. Wait a moment, and turn On.
9. Next, install Printer Driver & Utility. See 3.2 Network Quick Install.
Note:
• For further information on Web Image Monitor, please refer to the User Guide, p49.