5.System Maintenance
116
[-40.0 to 40.0 / 17.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 8.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 17.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 17.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 17.0 (Default) / 0.1 mm/step]
Clears the EM counter of the transfer roller.
Clears the EM counter of the fusing unit.
This menu is for resetting an SC related to a fusing error.
Adjusts the LD power.
[74 to 137 / 106 (Default) / 1/step]
Corrects the face curl of paper.
0: OFF (32ppm)
1: Sets the engine speed to half after printing 1 minute.
2: Sets the engine speed at 13ppm.
[0 to 2 / 0 / 1 /step]
Adjusts the printable sheets between "toner near end" and "toner
end".
[50 to 250 / 200 / 25 sheet/step]
Adjusts the printable dot count between "toner near end" and "toner
end".
[50 to 150 / 100 / 25 dot/step]
Adjusts the transfer roller bias.
[-6 to 6 / 0 / 1/step]
Adjusts the developer bias.
[270 to 330 / 250 / 15/step]
[1100 to 1300 / 1200 / 25/step]
Adjusts the fusing temperature for plain paper.
[150 to 200 / 175 / 1°C/step]
Adjusts the fusing temperature for recycled paper.
[160 to 180 / 170 / 1°C/step]
Adjusts the fusing temperature for postcards.