To Next PageTo Next PageWhat to do if Ricoh SP6330 Printer says 'Cover Open. Please close the Front Cover.'?
If your Ricoh Printer displays 'Cover Open. Please close the Front Cover.', ensure that the front cover is completely closed.
How to fix 'Load paper in (tray name)' error on Ricoh Printer?
If your Ricoh printer displays 'Load paper in (tray name)', it means the specified tray is empty. Load the correct paper into the indicated tray. Then, press the [Job Reset] button to restart the print job, or press [FormFeed] to initiate printing.
What to do if Ricoh Printer says 'Cover Open. Please close the Rear Cover.'?
If your Ricoh Printer displays 'Cover Open. Please close the Rear Cover.', ensure that the rear cover is completely closed.
What to do if Ricoh SP6330 Printer says 'Cover Open. Please close the Paper Exit Cover.'?
If your Ricoh Printer displays 'Cover Open. Please close the Paper Exit Cover.', ensure that the paper exit cover is completely closed.
How to resume printing on Ricoh SP6330 Printer when it's suspended?
To recover from a 'Printing Suspended' state on your Ricoh printer, turn the printer off, and then turn it back on again.
What to do if Ricoh SP6330 shows 'Paper size/type mismatch'?
If your Ricoh printer displays a 'Paper size/type mismatch' error, it means the paper type and size in all trays do not match the configured settings when Auto Paper Select mode is enabled. You can press [Change] to modify the settings, press [Job Reset] to reset the job, or press [FormFeed] to force printing.
What to do for 'Ethernet Board Error' on Ricoh SP6330 Printer?
If your Ricoh printer displays an 'Ethernet Board Error', it means an error on the Ethernet board has been detected. Try pulling out and then reinstalling the controller board.
What should I do if Ricoh SP6330 shows 'Connect failed:WirelessCard' error?
If your Ricoh printer displays the error 'Connect failed:WirelessCard', check to ensure that a wireless LAN board is installed. Verify that it is a supported board and that it is installed correctly.
What does 'Current wireless card is not WPA compatible' mean on Ricoh SP6330 Printer?
If your Ricoh printer displays the error 'Current wireless card is not WPA compatible', it means that the wireless LAN you are using is not compatible with WPA.
Why is PDF Direct Print not working on my Ricoh SP6330 Printer?
If PDF Direct Print is not working on your Ricoh printer, it could be because the optional hard disk is not installed, or the set RAM Disk size is too low. You must install the optional hard disk or set the value of [RAM Disk] in the [System] menu to 2 MB or higher.
General| Print Technology | Laser |
|---|---|
| Print Resolution | 1200 x 1200 dpi |
| Supported Operating Systems | Windows, Mac OS, Linux |
| Monthly Duty Cycle | 150000 pages |
| Connectivity | USB 2.0, Ethernet |
| Duplex Printing | Automatic |
