Enabled paper feeding tray Any input tray can be used.
• Make sure paper is not stacked higher than the upper limit
mark ( ) inside the tray. Make sure paper is not stacked
higher than the paper guides inside the bypass tray.
Both-sided printing Not possible
Additional cautions Print speed is slightly slower than when using plain paper.
OHP transparencies
Printer setup Make the following setting using the control panel:
Select [Paper Input] [Paper Type: Bypass Tray] [OHP
(Transparency)].
Printer driver setup Click [Transparency] in the "Paper Type:" list.
Enabled paper feeding tray This paper type can be printed only from the bypass tray.
Number of sheets that can be set Bypass Tray: 1 sheet
Both-sided printing Not possible
Additional cautions • Print speed for OHP transparencies is slower than for plain
paper.
• Depending on the setting made for mode switching, the
printer goes into standby mode 30 or 40 seconds after
receiving a job.
• We recommend you use a 4000 ANSI lumen or brighter
overhead projector to project OHP transparencies.
• When printing on OHP transparencies that have a print side,
load them with the print side facing up on the bypass tray.
• When printing multiple pages, remove output sheet as it
comes out. Do not leave multiple sheets remaining on the
output tray.
Envelopes
Printer setup Make the following setting using the control panel:
Select [Paper Input] [Paper Type: (tray name)] [Envelope].
5. Paper and Other Media
90
To Next Page
Loading...
