Ricoh SP6330 - Page 91

Printer driver setup Click [Plain (60 to 105 g/m
2
)] or [Plain & Recycled] in the "Paper
Type:" list.
Enabled paper feeding tray Any input tray can be used.
Number of sheets that can be set Tray 1: 500
Tray 2, Tray 3 (Paper Feed Unit): 500
Bypass Tray: 100
• Make sure paper is not stacked higher than the upper limit
mark ( ) inside the tray. Make sure paper is not stacked
higher than the paper guides inside the bypass tray.
Both-sided printing Possible
Additional cautions When printing on 91 - 130 g/m
2
paper, print speed is slightly
slower to when printing on paper of 60 - 91 g/m
2
.
Letterhead
Printer setup Make the following setting using the control panel:
Select [Paper Input] [Paper Type: (tray name)] [Letterhead].
Printer driver setup Click [Letterhead] in the "Paper Type:" list.
Both-sided printing Possible
Thick Paper
Paper thickness 105 - 216 g/m
2
(28 - 57 lb.)
• [Thick Paper 1]: 105 - 157 g/m
2
(28 - 42 lb.)
• [Thick Paper 2]: 157 - 216 g/m
2
(42 - 57 lb.)
Printer setup Make the following setting using the control panel:
Select [Paper Input] [Paper Type: (tray name)] [Thick Paper
1] or [Thick Paper 2].
Printer driver setup Click [Thick 1 (105 to 157 g/m
2
)] or [Thick 2 (157 to 216 g/
m
2
)] in the "Paper Type:" list.
Paper Recommendations
89
5