3. Adjust the side guides to the paper width.
• 45 g/m
2
(12 lb.) paper or paper of A3 or longer may not feed in properly unless it is cut at right
angles.
• If you load A4 or larger, slide out the Bypass Tray extension.
Specifying standard size paper for the Bypass Tray
This describes how to load standard size paper into the Bypass Tray.
1. Set the paper size using the control panel. Press the [Menu] key.
2. Press the [ ] or [ ] key to select [Paper Input], and then press the [OK] key.
5. Paper and Other Media
110
To Next Page
Loading...
